Standalone ECU / Motorsport

From First Start to Final Calibration

Standalone ECU · Custom Wiring & Config

Standalone ECU setup, commissioning, and calibration — scoped and priced per project, not by the hour. Terms/scope apply.

Scope is agreed before work begins.

Real Setups, Not Simulations

Standalone Media & Results

Project Scope & Pricing

Scoped and Priced Per Project

Depending on the agreed project scope, possible work includes: ECU/base configuration, firmware/config review, sensor scaling, crank/cam trigger verification, base timing, injector/ignition configuration, first start, idle/cold/warm behavior, DBW/idle control, drivability/transient tuning, load/power calibration, boost/wastegate control, safety/failsafe strategies, launch/traction/gear strategies where applicable, datalog review, dyno refinement, road/track refinement where agreed, and final calibration handoff. Not every project includes every item.

Scope is agreed before work begins.

Standalone calibration is quoted per project, not billed as an open-ended hourly tuning session.

  • Quote covers the agreed ECU/calibration scope on the hardware disclosed at intake.
  • Hardware/wiring/mechanical faults may require separate work.
  • Hardware changes after start may change scope.
  • Additional fuels/maps/features outside the quote may change scope.
  • External dyno/facility/travel/track costs are separate unless included.
  • Results depend on hardware, fuel, and mechanical condition.

Full Terms & Conditions apply.

How to Start

From First Contact to Final Delivery

Our roots are in ground-up standalone race setups — wiring, sensors, first start, and calibration — built on a 40-year mechanical tuning legacy and over a decade of modern calibration work. We don’t guess. We engineer power.


How a Standalone Project Runs

  • 1. Project review — hardware, sensors, trigger, fuel, and goals assessed before anything is agreed.
  • 2. Base strategy — a calibration plan matched to your ECU, engine, and intended use.
  • 3. Calibration session — in-person setup and tuning; remote support where the setup and data quality allow, confirmed during project review.
  • 4. Validation — logs, dyno, or track data proving the map does what it should, safely.
  • 5. Final handoff — the validated calibration delivered with its documented state.
Not a Basemap Shop

One thing worth being direct about: there’s no downloadable “stage” file or one-click basemap product here — every standalone calibration is built and validated against your own car.

Start Your Project

Motorsport Project Intake

1. Project

2. Hardware

3. Session & Quote

This records a session preference, not a confirmed booking.

Session Preference
Dyno Availability
Urgency

Request received.

Reference:

This is a session preference, not a confirmed booking. A real person will review and follow up by email.